1020142-A
14
English Manual
================================================================================================
Insert Transport Pin (
30
) in rear hole
same side as the Lift Handle Assembly
(
4
) as shown. Secure with Nylon Lock
Nut (
15
).
NOTE - Moving the wheels
in and out of transport mode:
Lift handle assembly (
4
) will pivot and
raise / lower the wheels. This transport
pin (
30
) allows the handle to be locked
in place during transport.
ASSEMBLY
Combine:
- x1 Hex Bolt (
21
) - 5/8” x 4”
- x1 Flat Washer (
24
) - 5/8”
Slide the bolt assembly through one wheel
(
11
) (wheel hub pointing toward the threads
of the bolt) and add:
- x1 Flat Washer (
24
) - 5/8”
- x1 Hex Nut (
17
) - 5/8”
Thread the hex nut as far as possible,
still allowing wheel to rotate freely.
Continue by running the hex bolt through
holes in Lift Handle (
4
)
(and Axle Assembly
(
10
) on the other end of the Aerator).
Secure with:
- x1 Lock Washer (
25
)
- x1 Hex Nut (
17
)
Tighten the inside Hex Nut while holding the
Hex Nut next to wheel stationary.
IMPORTANT:
The wheel hubs
are offset to one side. Make
sure the extended offsets are
installed toward plug aerator.
Step 8
21
24
24
17
25
17
11
4
30
15
4
30
15
4
Step 9