L-1884-
E
9.
Figure 4.
INSTALL TRANSMISSION & AXLE
4a. Maneuver the transmission
assembly (21) shaft into the
center hole of the Hopper
Assembly (2). Ensure that the
slot of the transmission brace
rests on top of the two tow tube
hex nuts previously installed in
Figure 2, as shown.
Note:
Failure to install the transmis-
sion bracket correctly may
void the warranty.
4b. Insert Axle (6) through both
Hopper Support (1) square
openings and through center of
transmission assembly (21), as
shown.
Note:
The axle needs to be installed
as shown in order to engage
the transmission assembly.
4c. Rotate the axle to line up the
hole with the hole in Transmis-
sion assembly hub and insert
Hairpin Cotter (40)
4d. Secure the transmission brace
by attaching two 5/16” Flat
Washers (32) and two Nylon
Lock Nuts (15), then tighten.
2
21
6
Axle only
goes on
one way
A
A
Install Axle - “A” is
equal lengths on
both sides.
1
1
BACK
Insert Hairpin Cotter
(40)
32
Flat Washer 5/16”
Qty. 2
40
Hairpin Cotter
Qty. 1
15
Lock Nut, Nylon 5/16”
Qty. 2
32
15
ASSEMBLY
