English Manual
12
1020313-A
G. CHANGING THE PUMP DRIVE BELT:
1. Remove fan guard.
Fig. G-1
Fan
Guard
4. Unhook spring from idler pully bracket.
5. Unhook idler pulley from the belt.
6. Unhook belt from engine pulley.
7. Pull belt through the top of the sulky, where the fan
guard was removed.
8. Install new belt through the top of sulky and around
transaxle pulley. Hook belt to engine pulley.
9. Hook belt to idler pulley.
See figure G-4.
10. Hook spring to idler pulley bracket.
11. Resecure the two (2) screws and nuts from the idler
pulley support bracket.
See figure G-3.
12. Reattach the skid plate.
See figure G-2.
13. Reattach the fan guard.
See figure G-1.
Skid Plate Hardware
Skid Plate
(Lightly
Shaded)
Skid Plate Hardware
2. Remove skid plate.
Fig. G-2
3. Remove the two (2) screws and nuts from the tensioner
bracket.
Tensioner
Bracket
Fig. G-3
Remove these
Maintenance
WARNING:
AVOID INJURY!
DISCONNECT THE SPARK PLUG WIRE TO PREVENT THE ENGINE
FROM ACCIDENTALLY STARTING BEFORE PERFORMING ANY MAINTENANCE ON THIS MACHINE.
Belt
Idler Pulley
Bracket
Fig. G-4
Spring
