BRINKS BHS-1200, Manual

Page: 14 / 25

TESTING THE BRINK’S SYSTEM
TRANSMISSION AND SIREN TEST
NOTICE: Your Protective Service Agreement requires that you test the
system each week.
1. Press and hold the “ 5 ” key for 3 seconds.
2. A test signal will be sent to the Brink’s Monitoring Center.
3. When the test signal is successfully received at the Brink’s Monitoring
Center, the keypad will beep, and the siren will sound a short blast.
(If the test signal is not successfully received at the Brink’s Monitoring
Center, the trouble light will be on. Call Brink’s Customer Service at
1-800-445-0872. Customer Service is available 24 hours a day, sevsn
days a week.)
NOTE: You will not receive a call from the Brink’s Monitoring center when
you use this feature.
TESTING THE DOOR AND WINDOW SENSORS
You can test the door and window sensors without sending alarm signals to
the Brink’s Monitoring Center.
1. Close all protected doors and windows.
2. Check the green ready light to see if on.
(if you cannot get the READY indication, call Brink’s Customer Service.)
3. Press and hold the “ 2 ” key for 3 seconds.
4. The keypad will beep.
5 Open and close each protected door and window one at a time. The
keypad will give a short tone to indicate that sensor is working. (Make
a note of each sensor that does not cause the keypad to give the tone
and call Brink’s Customer Service.)
6. When all doors and windows have been tested, press CANCEL to
exit the door chime mode.
NOTE: Door chime is automatically canceled when the system is
turned on.
13