1. Make sure the propane tank valve and regulator control valve are
turned OFF.
2. Make sure male SAE fitting is properly attached to air shutter (refer to
Assembly Instructions). Attach POL fitting to tank (using
f
" wrench)
and tighten by turning COUNTER-CLOCKWISE.
3. Prepare a soapy water solution (one part dishwashing liquid to three
parts water) to test for gas leaks in the hose and connections. Apply a
generous amount of the soapy mixture to the regulator, POL fitting,
control valve, the entire length of hose and SAE fitting (located near
the air shutter).
4. With the regulator control valve in the “OFF” position, open the
propane tank valve two full turns (counter-clockwise). Next, open the
regulator control valve fully and check for bubbles at control valve,
along the entire length of hose and at the SAE fitting. DO NOT LEAVE
GAS ON FOR MORE THAN 10 SECONDS. If soapy mixture starts
bubbling, gas is leaking through the connection or hose. Turn the
propane tank valve OFF and retighten the connection that is leaking
gas. Repeat procedure with soapy mixture until gas no longer leaks.
NEVER USE A FLAME TO CHECK FOR GAS LEAKS. Turn the propane
tank valve OFF after each test.
5. Once all gas leaks have been sealed, WAIT AT LEAST 5 MINUTES FOR
GAS FUMES TO DISSIPATE BEFORE LIGHTING THE BURNER.
CAREFULLY FOLLOW “OPERATING INSTRUCTIONS” ON PAGE 5
TO LIGHT THE BURNER AND PROPERLY OPERATE THIS UNIT.
GAS LEAK TESTING
THE GAS LEAK TESTING PROCEDURE MUST BE PERFORMED
EVERY TIME THE TANK IS CONNECTED TO COOKER.
WARNING
•
Gas leak testing must be performed outdoors in a well ventilated area.
•
During the gas leak testing procedure, always keep unit away from open flames, sparks or lit cigarettes.
•
Never use a flame to check for gas leaks.
•
If the burner does not light within 5 seconds, turn the propane tank valve and regulator control valve off
immediately. Always wait at least 5 minutes for gas fumes to dissipate before repeating procedure.
•
Always use the propane tank valve to turn the unit ON and OFF. The regulator control valve is used to adjust the
flame ONLY.
•
Never use a unit that has a gas leak. Contact The Brinkmann Corporation’s Customer Service Department for
replacement parts at 1-800-527-0717.
4
NOTE:
POL fittings are made with
a metal to metal seal and
must be made very tight
to prevent leaking.
Watch For Bubbles
Propane Tank
Valve
f
" Wrench
Regulator
