Brinkmann 810-2630-0, Owner'S Manual

Page: 21 / 28

Step 7
Attach the grease tray bracket onto
the back cart panel by inserting the
three tabs into the slots on the back
cart panel.
Note: When performing Step 8, Lift
grill body from front and rear
panels to avoid injury to
hands and fingers.
Step 8
With the help of a friend, place grill
body assembly on grill cart. Grill
body will rest between upper side
sections of cart. Align front edge of
grill body assembly with front edges
of cart frame legs. Secure using
four M6 X12mm bolts. At this point,
fully tighten six bolts holding back
panel from Step 6.
Note: To install battery, unscrew
igniter button cap. Insert
battery with positive end
towards button. Replace
igniter button cap.
20
OFF
HIGH HIGH
LOW LOW LOW LOW
HIGH HIGH
OFF
OFF
OFF
1. Read and follow all warnings and instructions
in owner’s manual before lighting.
2. Open lid before lighting burner.
3. Make sure all control knobs are in the OFF position.
4. Select the burner to be lit. Push and turn the control
knob of that burner to HIGH.
5. Press the electronic igniter and hold for 3-5
seconds to light burner.
6. If burner does NOT ignite immediately, turn control
knob to OFF, wait 5 minutes to allow gas to
dissipate and repeat lighting procedure.
7. Repeat Steps 4-6 for lighting each burner. Always
use electronic igniter for lighting each burner.
8. Refer to owner’s manual for match lighting procedure.
9. For assistance, call 1-800-527-0717.
10. To turn off, turn control knobs clockwise until it locks
in OFF position.
GRILL LIGHTING INSTRUCTIONS: SIDE BURNER
LIGHTING
INSTRUCTIONS:
1. Follow Steps
1-3 in GRILL
LIGHTING
INSTRUCTIONS.
2. Push and turn
SIDE BURNER
control knob to
HIGH.
3. Follow Steps
5-10 in GRILL
LIGHTING
INSTRUCTIONS.
FOR OUTDOOR USE ONLY
50
100
200
300
400
500
°
F
Grease Tray Bracket
Igniter Button Cap
OFF
HIGH HIGH
LOW LOW LOW LOW
HIGH HIGH
OFF OFF OFF
1. Read and follow all warnings and instructions
in owner’s manual before lighting.
2. Open lid before lighting burner.
3. Make sure all control knobs are in the OFF position.
4. Select the burner to be lit. Push and turn the control
knob of that burner to HIGH.
5. Press the electronic igniter and hold for 3-5
seconds to light burner.
6. If burner does NOT ignite immediately, turn control
knob to OFF, wait 5 minutes to allow gas to
dissipate and repeat lighting procedure.
7. Repeat Steps 4-6 for lighting each burner. Always
use electronic igniter for lighting each burner.
8. Refer to owner’s manual for match lighting procedure.
9. For assistance, call 1-800-527-0717.
10. To turn off, turn control knobs clockwise until it locks
in OFF position.
GRILL LIGHTING INSTRUCTIONS: SIDE BURNER
LIGHTING
INSTRUCTIONS:
1. Follow Steps
1-3 in GRILL
LIGHTING
INSTRUCTIONS.
2. Push and turn
SIDE BURNER
control knob to
HIGH.
3. Follow Steps
5-10 in GRILL
LIGHTING
INSTRUCTIONS.
FOR OUTDOOR USE ONLY
Alignment