Cleaning filters
To clean and change filters
1
Press ‘-’ key on unit display for 5 seconds.
2
Open the filter door and remove the
filters. Make a note of which way
round the filters are when removed.
You will need to replace them the
same way round.
3
Clean the filters* with a vacuum
cleaner (or fit new filters).
4
Replace the filters.
5
Close the filter door and switch on
appliance (press R key for 5 seconds).
Cleaning supply and extract valves
filter
door
G3
filter
4-way switch
display panel (on HRV unit)
Routine Maintenance
G3
filter
(optional
F7 Pollen filter
can be inserted
here)
Filters must be cleaned frequently
approximately every 2 months (depending
on usage), and should be replaced every year
to guarantee proper operation of the
ventilation system and to ensure good air
quality. This is especially important in a new
building.
There are two standard filters in the unit,
one to filter the incoming air (bottom slot) to
ensure good internal air quality, whilst the
other filter (top slot) protects the heat
exchanger.
An optional F7 Pollen filter may be fitted in
the bottom slot (replacing the standard
filter).
On the display or on the 4-way switch of the
Brink HRV you will get a signal when the
filters should be cleaned. A red LED-light on
the switch will show and the letters FILTER
will appear on the unit display .
After cleaning the filters or the fitting of new
filters, reset the filter indication on the front of
the appliance.
The display flashes shortly to confirm the filter
indication is reset. After this procedure, the
display is back in position.
Cleaning of the supply or extract valves with
soap and water should be done on a regular
basis depending on their condition.
display
* Due to the design of the F7 Pollen Filter
cleaning is not advised.
