Brilliant Fires Limited ROMANCE, User, Installation And Servicing Instructions

Page: 4 / 16

4
or keep pressing to lower slowly then release
the button at the desired position.
TO INCREASE THE HEAT SETTING
Point the handset at the sensor on the fire.
Press and hold the plus button (marked with a
large flame). Alternatively press and hold the
plus button on the appliance (marked with a
small flame). When the fire beeps release the
button immediately to turn to the lowest setting
or keep pressing to increase slowly then release
the button at the desired position.
TO PUT THE FIRE INTO STANDBY MODE
This setting keeps the pilot lit and turns the
main burner off, allowing the fire to be re-lit
without going through the start up sequence,
saving time and battery power.
Point the handset at the sensor on the fire. Push
and hold the small round button (marked with
STAND-BY). Alternatively press and hold the
small button on the appliance (marked with
STAND-BY). When the fire beeps release the
button.
TO TURN THE FIRE OFF
Point the handset at the sensor on the fire.
Press and hold the large round button (marked
with a dot). Alternatively press and hold the on/
off button on the appliance (marked with a star
and dot). When the fire beeps release the
button.
BATTERY INFORMATION
The burner batteries will need replacing when
they are exhausted. The control system will
sound beeps when this is required as follows:-
Always dispose of used batteries in accordance
with the local authority regulations.
TO REPLACE THE BURNER BATTERIES
The battery holder is situated under the fire and
is fitted with 6 AA batteries. When replacing the
batteries all 6 batteries must be replaced at the
same time using new alkaline AA or equivalent
batteries,
DO NOT mix old and new batteries.
To replace the batteries the holder must be
removed from the fire, carefully disconnect the
battery lead as shown in Figure 5A.
Lift the battery holder upwards until it touches
the locating bracket top and slide it forwards
and out of the locating bracket (Figure 5B). The
batteries can now be removed. It is easiest to
remove the middle battery first on each side of
the holder.
When fitting the new batteries, ensure correct
polarity by referring to the polarity diagrams
inside the battery holder. Replace the battery
holder and reconnect the battery lead.
TO REPLACE THE HANDSET BATTERY
If the handset battery
requires replacing turn
the handset over and
remove the battery
cover (Figure 6).
Pull out the battery and
carefully disconnect it
from the lead. The replacement battery must be
a new alkaline PP3 or equivalent battery.
CAUTION
Standby is not a fully off position and
should only be used for short periods.
On standby the burner may on
occasions not fully turn off and may
also remain alight on a very low
setting. This is a normal characteristic
of the control unit.
CAUTION
When lit, DO NOT
DO NOT DO NOT
DO NOT place the handset
on top of the fire or near to the burner
flames as damage will occur.
6
Push Clip and Lift Cover
CAUTION
Before reporting a fault on your fire
ensure the battery is in good condition
(i.e. single beep)
BEEPS DIAGNOSIS INFORMATION
6 REPEATED Very low burner batteries - Replace burner batteries
7 REPEATED Low burner batteries - Replace burner batteries
5A
Remove Connector
5B
Lift Holder Up and Slide Out