Brilliant Fires Limited NEWDAWN ELECTRIC, User And Installation Instructions Manual, Page: 10 / 20

10
Brilliant Electric fires meet the requirements of
the EC Directives 2004/108/EC and 2006/95/EC.
These directives have been met by compliance
with the following standards:
BS EN 60335-1:2002
BS EN 60335-2-30:2003
BS EN 6100-6-3:2001
Please read these instructions before installation
or use and keep this booklet handy for future
reference.
SAFETY
This appliance is not intended for use by persons
(including children) with reduced physical, sensory
or mental capabilities, or lack of experience and
knowledge, unless they have been given
supervision or instruction concerning the use of
the appliance by a person responsible for their
safety.
Children should be supervised to ensure they do
not play with the appliance.
GENERAL WARNINGS
Never leave children unsupervised with an
unguarded heater.
Never obstruct or cover the heater outlet.
Never install or use the heater where it may come
in contact with water.
Never use aerosols or steam cleaners near the
heater.
Never route the electric cable near the heater
outlet.
Never route the electric cable under carpet
Never install the heater close to curtains or
combustible materials.
Never use the heater to dry clothes or other
objects.
Never remove the controls cover without isolating
the electric supply.
IMPORTANT ELECTRICAL SAFETY
This appliance must never be installed above or in
front of a fixed electric socket. The electric socket
must be easily accessible to isolate the supply
during maintenance and cleaning.
This appliance is supplied with a two metre power
lead. Depending on the model, the power lead may
have a moulded three pin 13 amp-fused plug to
connect to your electric wall socket. This
appliance must always be earthed. If in any doubt
consult a suitably competent person.
The electric supply must be safely routed from the
appliance to an electric wall socket. If the electric
cable is damaged it must be replaced by a genuine
Brilliant part. All external wiring to the heater
must comply with IEE regulations.
In order to avoid a hazard due to
inadvertent resetting of the thermal
cut-out, this appliance must not be
supplied through an external switching
device, such as a timer, or connected to
a circuit that is regularly switched on
and off by the utility.
WARNING
PRODUCT
NAME
PRODUCT
CODE
SERIAL
NUMBER
BATCH
NUMBER
FREQUENCY
2
RATED
INPUT
FUSE
RATING
RATED
VOLTAGE
DATA BADGE LOCATION 1