Toss Brightz
™
Installation Instructions
©
Copyright Brightz, Ltd. 2015
Patent Pending
All rights reserved
Step 1 – Install batteries
From the BACK of the battery holder slide the back up to remove the battery cover. Install 3 fresh AA batteries,
observing the correct polarity (+/-). Replace battery cover.
Do not mix old and new batteries and do not mix
alkaline, standard (carbon-zinc) or rechargeable (ni-cad, ni-mh, etc.) batteries.
Step 2 – Positioning and installing the LED lights around the hole
Turn board over so the back side is facing up and attach LED lights using three (3) screw-in fasteners as shown.
Adhere the battery pack to the board with the attached hook and loop fastener.
NOTE: Lights are waterproof
but battery pack is not.
TOP END OF BOARD
Clip
Clip
Clip