快速安装手册
http://www.whkj.com.cn
010
‐
51655555
●装纸 Paper Roll
安装步骤:
1.如图 2 翻开活动纸仓盖。
2.接着将打印纸装入,并拉出一截(超出一点撕纸牙齿),注意把纸放整齐,纸的方向如图 1
所示。
3.对准机头的打印纸入口,接通打印机电源,按下 SEL 按键使 SEL 指示灯熄灭,然后按一
下 LF 键,这时机头开始走动。用手将纸送入机头入口处,这时纸便会徐徐进入机头,
直到从机头上方露出为止,露出应有一定长度。再按一下 SEL 键,或关上电源。
4.关上活动纸仓盖即可。
T2 为易装纸型,无需参考此步骤。(热敏型注意装纸方向,应有药液一面(光滑面)向下)
Replacing the Paper Roll
1. Open the paper cover.
2. Insert the paper roller into the printer, Pull out a small amount of paper and
insert the paper into the feeder. Notice the direction of the paper when using
Thermal series according to Fig.1.
3. Power the printer on, press SEL button, make SEL indicator light off, then press
LF button, make the print head to run, and the paper will come out. Press SEL
button again or turn off the power.
4. Close the paper cover.
(Note: When use T2 printer with easy paper
loading, no need to refer this step.)