Bright Solutions BSL1610SE, Owner'S Manual

Page: 6 / 21

”
3) Continually check for foam buildup
in recovery tank. Use a distributor
recommended foam control
solution.
NOTE: Excessive foam buildup will not
activate the float shut-off and may
cause damage to the vacuum motor.
4) Repeat extraction path on heavily
soiled areas.
5) If brush stops spinning, there may
be an obstruction in the brush.
Unplug the power cable, raise the
brush off the floor and check for
an obstruction. Check & reset the
brush circuit breaker located on
the control housing.
6) When recover of the dirty solution
ends, or the solution tank is empty,
you must drain the recovery tank.
(see TANK DRAINING)
USE OF ACCESSORY TOOLS
NOTE: Prior to cleaning upholstery, be
sure to read cleaning instructions
provided by the manufacturer.
1) Disconnect black vacuum hose off
the back right side of the machine.
Connect (optional) accessory
vacuum hose to area where the
standard vacuum hose was
removed.
2) Connect (optional) accessory
solution hose to brass quick
connect coupler located on the
back of the machine.
3) Connect (optional) accessory tool
to solution and vacuum hoses.
4) Turn on vacuum / pump switch.
5) Operate accessory tools as needed.
6) When cleaning is completed,
relieve water pressure from
solution lines by turning off
vacuum / pump switch and then
squeeze trigger for 4 seconds.
6
DRAINING TANKS
DRAINING SOLUTION TANK
1) Disconnect vacuum hose from back
of machine and connect the
“
bleeder
”
vacuum hose (included
with machine) to the machine back.
2) Remove the solution tank filter at
the fill area and place end of
“
bleeder
”
hose into the bottom of
the tank.
3) Turn on vacuum / pump switch &
vacuum out the remaining solution.
DRAINING RECOVERY TANK
1) Turn off machine, unplug and
remove power cable.
2) Unhook drain hose off the back of
the machine and remove drain
hose stopper.
3) Drain dirty solution into floor drain.
4) Replace drain hose stopper and
reattach hose to back of machine.
MACHINE MAINTENANCE
To keep the machine performing
well for many years, please follow
the following maintenance
procedures.
!!! Always confirm that the
machine is unplugged prior to
performing any maintenance or
repairs!!!