17
3. Pull back on collar, insert turbo nozzle and release
collar (Figure 27). Tug on turbo nozzle to make sure it
is securely in place.
4.Disengage trigger lock on spray gun trigger.
To attach the turbo nozzle to the spray gun:
Threaded Connection
1. Engage trigger lock on spray gun trigger.
2. Remove nozzle extension from spray gun, if attached.
3. Attach turbo nozzle extension to spray gun (Figure 28).
Tighten by hand.
4. Disengage trigger lock on spray gun trigger.
For most effective cleaning, keep turbo nozzle from 8 to
24 inches (20 to 61 cm) away from cleaning surface. If you
get turbo nozzle too close, you may damage cleaning
surface.
NOTE
: Detergent cannot be applied with the turbo nozzle.
Cleaning and Applying Detergent
To apply detergent follow these steps:
1. Review use of adjustable nozzle or spray tips.
2. Prepare detergent solution as required by
manufacturer.
3A. Place detergent siphoning tube/filter in detergent
container.
NOTE:
Make sure the filter is fully submerged while applying
detergent.
3B. If equipped, pour detergent solution into cleaning tank.
4A. If equipped with adjustable nozzle, slide the adjustable
nozzle forward to low pressure position. Detergent
cannot be applied with nozzle in high pressure position.
4B. If equipped with quick-connect spray tips, make sure
the black spray tip is installed. Detergent cannot be
applied with high pressure quick-connect spray tips.
5. Make sure garden hose is connected to water inlet.
Check that the high pressure hose is connected to
spray gun and pump. Turn on water.
6. Engage trigger lock on the spray gun and start engine
following instructions in
How to Start your Pressure
Washer.
7. If equipped with a cleaning tank, rotate detergent shut-
off valve on cleaning tank to “
On
” position (see Figure
29).
8. Apply detergent to a dry surface, starting at lower
portion of area to be washed and work upward, using
long, even, overlapping strokes.
9. Allow detergent to “soak in” between 3 to 5 minutes
before washing and rinsing. Reapply as needed to
prevent surface from drying. Do NOT allow detergent to
dry on surface (Prevents streaking).
IMPORTANT:
If unit is NOT equipped with a cleaning tank,
you must flush the detergent system after each use by
placing the filter into a bucket of clean water, then run the
pressure washer in low pressure for 1-2 minutes.
NOTICE
• Starting the engine without all the hoses connected and without
the water turned ON will damage the pump.
• Damage to equipment resulting from failure to follow this
instruction will void warranty.
You must attach all hoses before you start the engine.
NOTICE
• When inserting the filter into a detergent solution bottle, route
the tube so as to keep it from inadvertently contacting the hot
muffler.
Keep the detergent siphoning tube/filter from coming in
contact with the hot muffler.
Figure 29 — Detergent Shut-Off Valve
“On” Position
Figure 27- Attaching Turbo Nozzle to Quick Connect Nozzle
Extension
CAUTION
Chemicals can cause bodily injury, and / or property
damage.
• NEVER use caustic liquid with pressure washer.
• Use ONLY pressure washer safe detergents/soaps. Follow all
manufacturers instructions.
Figure 28- Attaching Turbo Nozzle to Spray Gun
