Not for
Reproduction
16
Assembly
Install Chute Rotator Switch
Non-Electric Height-of-Cut Units
NOTE:
Model year tractor’s 2012 and earlier with non-
electric height of cut refer to service bulletin 2009-2 for
proper chute electric component requirements. Model
year tractor’s 2009 to present continue with manual
instructions. Non electric height-of-cut units can be
identified by the flat plug in the dashboard as shown in
Figure 21.
1. Plug female connector of the switch wire harness (a,
Figure 21) into chute control switch (M).
a
M
Figure 21
2. Remove plug (b, Figure 22) from right side of
dashboard.
b
Figure 22
3. Route the switch wire harness (a, Figure 23) with
attached switch (L) through opening in dashboard.
Snap switch into dashboard to secure.
a
L
Figure 23
4. Locate the tractor power leads (Figure 24), red with
yellow stripe (c) and black (d), at the base of steering
column. Connect these leads, color to color, to the
switch wire harness (a).
c
c
a
d
Figure 24
5. Thread switch wire harness (a, Figure 25) through bulk
head.
a
Figure 25
6. Proceed to “Install Wire Harness to Chute Harness”
section.
Electric Height-of-Cut Units
• On units with electric height-of-cut, use the toggle
switch (a, Figure 26) located on the left side of
dashboard for chute rotation.
• Push toggle up or down to rotate left or right.
a
Figure 26
