Fiche technique
ST FRE170
33
TROUBLE SHOOTING
If there is something wrong during operation, it may not be the unit’s problem. You may check against
the following list before send for repair.
Problems
Possible reasons
Solutions
Not working
1.
The plug is not
securely inserted into the
socket or not connected
well.
2.
The “ON/OFF” button
is not pressed.
1.
Insert the plug pin into
the wall socket and
make
sure
it
is
connected well.
2.
Press
“ON/OFF”
button after plugged.
Cool effect not good
1.
Water
tank
not
enough water
2.
Water
pump
is
obstructed.
1.
Add water to ensure
there is enough water for
pumping
2.
Clean
water
tank
discharge impurities.
NOTE:
THIS INSTRUCTIONAL CHART IS FOR REFERENCE PURPOSES ONLY, IF ANY TECHNICAL
ASSISTANCE IS NEEDED, PLAESE CALL STAR PROGETTI'S OFFICES FOR SERVICE/REPAIR AT
NO. 02/90639261
RECOMMENDATIONS FOR USE
• In order to avoid any water sprays to come out from the fan, the cooler, under normal working
conditions, should be placed on a flat surface, and its cellulose panels perpendicular to the floor.
• When it is first switched on, it is recommended to fill the tank as per instructions and run one-
hour cycle at least with the COOL function ON and the fan operating speed set to the minimum.
If the appliance is operated at the maximum air flow from the very start, it may cause the passage of
water from the cellulose panel to the fan, causing water sprays from the front of the cooler and
possible damages to the bearing of the fans themselves.
• The first time it is switched on, you might feel an unpleasant smell of the cooled air, caused by
the new cellulose panel. We suggest you should complete at least one cooling cycle outdoors in an
open space (fill a water tank, start the COOL function and let the appliance work until it finishes water
completely), before positioning and using it at the final place.
• You can also add ice to water, to maximise the appliance performance in the hottest weather, as
well as scented essences (to distribute cooled and scented air in the zone of use). Be however sure
to use water-based essences so as to avoid clogging the filter by oils or soaps, which may affect the
effectiveness and proper functioning of the cooler.
• It is suggested to run a lime washing cycle at least once in a year, by adding one litre of white
vinegar in the water tank and activating the COOL function until the tank is completely exhausted.
Once the cycle with vinegar is ended, fill again the tank by water only and repeat the procedure.
PROTOUMAT - 35 route de Colmar, 67600 Sélestat
Tél. : 03 88 08 65 06
SIRET : 444 448 898 00015
Fax : 03 88 08 67 39
33
STAR PROGETTI / PROTOUMAT | ST FRE170 | 11/2022
