12
Care, Cleaning
& Storage
WARNING
Before cleaning or maintenance of the
dehumidifier, ensure the power is switched
off at the outlet and the plug is removed.
CLEANING YOUR DEHUMIDIFIER
1. Keep the unit upright when cleaning.
2. Wipe the dehumidifier housing, control
panel and air inlet and outlet grilles with
a soft, dry cloth.
3. To remove dirt that may have built up on
the housing body and air inlet grille, wipe
with a damp cloth only. Do not use on the
control panel.
WARNING
Do not clean the control panel with a damp
cloth. Do not clean the unit with gasoline,
thinner or liquid detergent as chemical
substances may damage the humidifier screen
or change the colour of the dehumidifier.
NOTE
Using a brush may scratch the dehumidifier.
Do not use any objects that may scratch the
unit.
WATER TANK CLEANING
NOTE
The dehumidifier cannot operate if the tank is
full or is not installed correctly. Clean the water
tank once a week if used regularly.
1. Remove the water tank from the back of
the dehumidifier by holding the sides and
pulling outwards.
2. For the Smart Dry Plus™ Dehumidifier only
(LAD300) remove the lid before cleaning.
Place the tank on a dry, level surface. Flip
the handle on the water tank cover until the
grooves in the handle match the grooves in
the handle holders. Pull outwards on both
sides of the handle to disengage. Once the
handle has been removed, carefully pull
upwards on the tank lid to remove.
3. Tip any excess water from the water tank
into a sink or drain, then rinse the inside of
the tank with clean water.
4. Wipe any water on the outside of the tank
with a dry cloth and replace the water tank
lid and handle back onto the water tank
(LAD300 only).
5. Replace the water tank back into the
dehumidifier.
WARNING
Water in the water tank is not suitable for
drinking. Do not drink this water, and do not
serve to animals or use to water plants.
LAD300_200_ANZ_IB_B19.indd 12
8/4/19 1:56 pm
