11
Care, Cleaning
& Storage
Before cleaning the humidifier, ensure the power
is switched off at the outlet and then remove the
power plug.
BREVILLE RECOMMENDS
•
Only use cold water or distilled water in
the water tank.
•
Change the water often to keep it fresh.
•
Clean the transducer, water tank and water
basin at a minimum of once every week when
in constant use.
•
Use the brush provided or a cotton swab to
assist with cleaning the transducer and basin.
Never use metal or sharp objects.
•
After cleaning, ensure all parts are completely
dry before using the humidifier.
IMPORTANT
If you do not use the humidifier for a long
time, clean and dry the water tank and all
parts before storage.
IMPORTANT
Do not use chemicals, steel wool, metal scouring
pad or abrasive cleaners to clean the outside of
the humidifier housing as these can damaged the
housing of the humidifier.
IMPORTANT
Cleaning procedures must be routinely
followed to ensure that the humidifier
continues to operate efficiently.
NOTE
Clean the whole humidifier and make sure that
all parts are dried completely if not in use for a
period of time. Use a damp cloth only. Do not
immerse the unit in water. Clean the transducer,
water tank and basin at least once a week.
IMPORTANT
In cases when the water is hard (where water
contains too much calcium and magnesium),
it may lead to a 'white powder' residue and
leave heavy scale on the surface of water basin,
transducer and inner surface of the water tank.
Scale, or calcification, on the surface of transducer
will reduce the reliability of the unit.
WARM MIST
This humidifier has a warm mist feature. When
selected, a small internal heating element will
heat the water to create a warm vapour.
1. Turn the humidifier on and select the desired
mist level as detailed in this book.
2. Press the WARM MIST button on the
control panel. There will be a beep and the
light will turn red to indicate this feature is
on. Cold mist will start to emit from the mist
nozzle and gradually within 10–15 minutes,
the warm mist will emit from the mist nozzle.
3. To turn this feature off, press the WARM
MIST button again. There will be one beep
and the red light will extinguish.
NOTE
The warm mist will start after the water has
time to heat. The time will vary depending on
factors such as the temperature of the water in
the tank.
AROMA TRAY
1. Press the aroma tray on the side of the
humidifier and it will click out of the unit.
2. Add 2–3 drops of essential oil (not included)
directly to the pad in the aroma tray.
3. Push the aroma tray back into the humidifier
until it clicks into place.
4. Turn the humidifier on and the aroma will
start emitting automatically with the mist.
Increase the mist intensity as desired.
IMPORTANT
Never add essential oil directly to the water tank,
the water inlet basin or any other part of the
humidifier except the aroma tray felt pad. Do not
use more than 2–3 drops of oil on the aroma tray
felt pad at any one time. Only add more oil when
the aroma in the surrounding air has dissipated.
IMPORTANT
Do not use the humidifier unless it has been
cleaned according to the instructions found in
the Care, Cleaning & Storage section of this book.
