10
LCD SCREEN DISPLAY MENU
HOT
Appears on the screen only when the HOT
button has been selected.
AMBIENT
Displays on the screen as the default for when
in standby mode.
FILTER RESET
Appears on the screen as a reminder to change
the filter cartridge once the filter life timer has
counted down.
DESCALE
Appears on the screen every 6 months as a
reminder to descale the machine.
NOTE
To descale more often than the programmed
descale reminders, press and hold the HOT
button for 3 seconds until Descale appears on
the screen.
To quit descale mode, press and hold the HOT
button again for 3 seconds.
FILL TANK
Appears on the screen when the water tank
level is low. The purifier will not dispense water
until the tank is refilled.
The unit will beep 3 times and FILL TANK
will flash on the LCD screen. The water droplet
light on the START/STOP button will turn to
solid red to alert the user that the water tank
needs to be filled.
Once the unit has been filled, FILL TANK will
no longer illuminate on the LCD screen.
NOTE
Take care when removing the water tank from
the base after use as residual water may drip.
NOTE
•
The purifier will not dispense any water while
the tank is below the minimum water level.
•
Ensure the water level is always above the
MIN level for optimum flow rate.
TEMP (°C) CONTROL & VOLUME (MLS)
When CUSTOM menu is selected, setting the
temperature (between 45°C-100°C) and the
volume of water dispensed (between 100mL-
1.2L) can be manually adjusted.
For AMBIENT, only the volume of water can
be manually adjusted (between 100-500ml).
HOT BEVERAGE MENU
Press the HOT button to enter the MENU.
Turn the FUNCTION dial to navigate the
menu, then press the dial to select.
NOTES
•
Hot water temperature settings are measured
at the heating element, not the dispensed
temperature at the spout or in the cup.
•
This appliance is not calibrated for
commercial or scientific use. Temperatures
may vary +/-2°C, which is within range for
optimal brewing for each hot beverage menu.
•
The appliance is calibrated at sea level hot
water temperatures. High altitude locations
will have an impact on hot water temperatures
due to low atmospheric pressure.
•
When dispensing ambient water, if
START/STOP is not pressed to stop
dispensing, the purifier will automatically stop
after 60 seconds.
•
Ambient water temperature will vary. The
temperature dispensed will be influenced by
the external factors surrounding the purifier
itself. An increase in the air temperature will
cause water tank temperature to increase as
well.
•
If the water temperature in the tank becomes
too warm, discard and replace with cold tap
water. Water temperature in the tank should
not be dispensed if above 40°C.
