Bretford 1-Bay, User Manual

Page: 2 / 6

Technical Specifications
Size and Weight
Model 1-Bay 5-Bay 10-Bay
Dimensions
19 x 19 x 4.75 in
48.3 x 48.3 x 12.x cm 19 x 19 x 21 in
48.3 x 48.3 x 53.4 cm 19 x 19 x 67 in
48.3 x 48.3 x 53.4 cm
Weight
25 lbs
11.3 kg 86 lbs
39.0 kg 217 lbs
98.4 kg
Charging
Each bay of the TechGuard Locker offers:
One (1) AC outlet, supports up to a 100 W power adapter.
Two (2) USB charging ports, up to 2.4 A each.
Electrical and Operating Requirements
The TechGuard Locker has been engineered to charge all connected devices from a single
15 A AC circuit.
Maintenance-free keypad locks are powered by the internal system power supply. No
batteries required.
Administration Keycards
Access Keycard
The Access Card will open a bay but keep the current unlock code, allowing facilities personnel
to inspect contents of an in-use locker.
Reset Keycard
The Reset Card will open a bay and reset the current unlock code, in the event of a forgotten
code.
Using An Administration Keycard
1. Hold the appropriate card up to the keypad next to the locker bay you wish to access or
reset.
2. The keypad will unlock and respond with an audible confirmation.
Important Keycard Information
Each TechGuard locker includes two administration keycards, one (1) access and one (1)
reset.
Each pair of cards will only allow access to the TechGuard Locker in which they are
included. They cannot be shared with multiple 1-Bay, 5-Bay or 10-Bay units.
Always keep your keycards in a secure location.
TechGuard Accessories
The following accessories are available from Bretford for TechGuard Charging Lockers:
Lightning cable with retaining clip (1-pack / 5-pack)
Micro-USB cable with retaining clip (1-pack / 5-pack)
Jump Starter Kit, used to power Keypad and door lock during power outages
JumpStarter Accessory Kit
The optional JumpStarter Accessory Kit provides temporary power to a TechGuard Charging
Locker during a power outage, allowing users and administrators to open locker bays with the
user’s passcode, or the administrator keycards.
The JumpStarter Accessory Kit includes:
JumpStarter port opener tool
Battery pack
JumpStarter connection cable
To use the JumpStarter Accessory Kit to open a locker:
1. Use the JumpStarter port opener tool to pry open the JumpStarter port cover. Slide the
keyed end of the tool into the notch on the bottom edge of the port cover until it clicks, and
gently pry open the cover.
2. Plug the JumpStarter connection cable into the battery pack and connect to the JumpStarter
Accessory Port.
3. The battery will begin providing power to the keypads so they can be opened normally,
using the user’s passcode or an administrator keycard.
The JumpStarter Accessory Kit does not provide charging power to connected devices in each
bay.
More information about the JumpStarter Accessory Kit is available at bretford.com/techguard.
Getting Started
Installing Your TechGuard Locker
Where To Install
Before installing your TechGuard Charging Locker please read the Safety section of this User
Guide.
Powering Your TechGuard Locker
Step-By-Step
1. Locate and unwrap the region specific AC power cord provided with your TechGuard
Locker.
2. Connect the power cord to the rear side of the TechGuard Locker.
3. Connect the power cord to a dedicated 15 A circuit.