Bresser WEATHER CENTER, Instruction Manual

Page: 58 / 200

58
At certain locations (especially those at high latitudes), sunrise and sunset events may not occur
within a 24 hour time frame.
Display Sunrise status Display Sunset status
FULL Sunrise at previous day FULL Sunset at next day or later
---- No sunrise for the whole day ----- No sunset for the whole day
Temperature and Humidity Mode
The weather center supports up to 5 remote thermo-hygro sensors, each sensor corresponding to a
separate channel for the temperature and relative humidity display. The temperature may be shown
in degrees Celsius ºC or degrees Fahrenheit ºF. The trend (rising, steady or falling) of all values is
also indicated on the display.
The main console unit uses the indoor temperature and humidity data to compute a comfort level
rating of Wet, Comfort or Dry.
A temperature alert function is available for each channel. It can be programmed to sound if the
channel temperature exceeds or falls below the pre-confi gured upper and lower limits.
Note: The temperature alerts have a 0.5 ºC hysteresis to prevent the alerts from sounding constantly
due to small fl uctuations near the alert value. This means that after the temperature reaches the alert
value, it will have to fall below the alert value plus the hysteresis to deactivate the alert.
Accessing Temperature and Humidity Mode
From the main console unit: Press UP or DOWN until the IN icon of the display
starts fl ashing.
Viewing Temperature and Humidity Display for each Channel
For Static Display:
In Temperature and Humidity Mode, each press of CHANNEL rotates display between different
channels.
For Cycling Display:
To enable automatic rotating between different channel displays, press and hold CHANNEL, until
the icon is displayed. Each valid channel will now be alternately displayed for 5 s.
Rotating Between Temperature and Dew Point Display
In Temperature and Humidity Mode, each press of SET rotates temperature display between:
- Temperature and Relative Humidity
- Dew Point Temperature and Relative Humidity
Setting Units for Temperature Display (ºC or ºF)
In Temperature and Humidity Mode, press and hold SET to convert units between degrees
Celsius ºC and degrees Fahrenheit ºF.