26 / 36
Depending on the desired location, the remote sensor can be installed in different ways.
NOTICE! During the assembly make sure that the upper part of the wind vane is minimum 1.5
metres off the ground. Use the circular level in the sensor head to ensure a level installation. The
windmill must point to the North.
Assembly on a vertical or horizontal tube
1. Insert the stainless steel mounting pole into the mounting hole of the sensor and tighten the
screws firmly.
2. Attach the stainless steel pole to a post or pipe using the 2 U-bolts, mounting clamps and nuts.
11 Base station
Once the power is connected, the console status LED will light up red, and after a few seconds, the
base station will show the Wi-Fi connection status:
1. If the base station has not yet been connected to a router, it first switches to AP (Access Point
mode) mode. The status LED flashes green. The station is now ready for setup. Follow the instruc-
tions in Section 13.
2. If the base station was already connected to a router, it will try to re-establish the connection. The
status LED flashes blue.
3. After successfully connecting to the router, the status LED lights up blue. Die Station is now ready
for use.
Status LED Base station:
Status
LED Status
Startup
LED flashes red for approx. 7 seconds
AP mode (Access Point Mode) to set up the
router connection
LED flashes green
Connection establishment or connection failed
LED flashes blue
Connected to Wi-Fi router
LED lights up blue
Firmware update
LED flashes red
Refresh the upload data by pressing the RE-
FRESH button
LED flashes purple
12 Setting up an user account for other weather
services (e.g. AWEKAS)
1. You have the possibility to use a weather service of a third party provider, as shown here with the
example of AWEKAS.
2. Enter the following web address in the address bar of the web browser for the 'AWEKAS' service:
https://join.awekas.at
3. Fill in all the necessary information.
4. Make a note of the information: Username, Password, Geographic latitude (Latitude) in decimal
degrees (e.g. 48.30591), geographical longitude in decimal degrees (e.g. 14.2862).
NOTICE! Use a valid e-mail address for registration. Otherwise the service can not be used.