19 / 24
10 Alarm setting
1. Press and hold ALARM button for approx. 3 seconds to enter the alarm time setting mode.
2. Digits to be set are flashing.
3. Press UP or DOWN button to change the value.
4. Press ALARM button to confirm and continue to the next setting.
5. Settings order: Hours > Minutes
6. Finally press the ALARM button to save the settings and exit the setting mode. Alarm will be activ-
ated automatically. The symbol will be displayed.
7. Press ALARM button in normal display mode to display the alarm time.
8. Press ALARM button during the alarm time display to disable the alarm.
11 Snooze function
1. When the alarm sounds, press the SNZ/LIGHT button to activate the snooze function. The alarm
sounds again after 5 minutes.
2. When the alarm sounds, press any other key to stop the alarm until the set alarm time is reached
again.
12 Moon phases
The following table shows the representations of the moon phases.
1
2
3
4
5
6
7
8
1 New moon
2 Waxing crescent
3 First quarter
4 Waxing gibbous
5 Full moon
6 Waning gibbous
7 Third quarter
8 Waning crescent
13 Connecting remote sensors
The Weather Station can display the readings from up to 3 wireless sensors* of the same type. Each
radio sensor must be set to a separate channel. Proceed as follows to set the channel:
1. Remove the battery compartment cover of the wireless sensor.
2. Set the channel selection switch to the desired channel (CH1, CH2 or CH3).
3. Re-attach the battery compartment cover.
