Bresser BR-PH30 Instruction Manual Download Page 7

7

About this Instruction Manual

These operating instructions are to be 

considered a component of the device.

Please read the safety instructions and the operating 

instructions carefully before use.

Keep these instructions for renewed use at a later 

date. When the device is sold or given to someone 

else, the instruction manual must be provided to the 

new owner/user of the product.

Intended Use

This product is intended only for private use. The 

device is intended only for indoor use. 

General Warning

 RISK OF CHOKING!

Keep packaging material, like plastic bags and 

rubber bands, out of the reach of children, as these 

materials pose a choking hazard.

 RISK of ELECTRIC SHOCK!

This device contains electronic components that 

operate via a power source (power supply). Only use 

the device as described in the manual; otherwise, 

you run the risk of an electric shock.

Position your device so that it can be disconnected 

from the power supply at any time. The wall socket 

you use should be located near the device and easily 

accessible, since the plug on the power cable serves 

as a disconnecting device for the power supply.

Always pull on the plug to separate the device from 

the power supply. Never pull on the cable.

Never bend, pinch or pull the power and connecting 

cables, extensions and adapters. Protect the cables 

from sharp edges and heat.

Before operating, check the device, cables and 

connections for damage. Never use a damaged unit 

or a unit with damaged power cables. Damaged 

parts must be exchanged immediately by an 

authorised service centre.

 RISK of FIRE/EXPLOSION!

Do not expose the device to high temperatures. 

Use only the supplied power adapter. Do not short-

circuit the device or throw them into a fire. Excessive 

heat or improper handling could trigger a short-

circuit, a fire or an explosion.

   NOTE!

The manufacturer is not liable for voltage damage 

due to the use of an improper power adapter.

What to do in case of a lamp break?

The quantity of mercury used for the light tubes and 

energy-saving lamps is very low. The consumer will 

get in contact with the mercury in case of a lamp 

break (broken flash tube). The quotation of mercury 

that may the customer get in contact with is very 

low and in most cases the concentration is below 

German limiting values.

When a lamp is broken, disconnect the light from the 

main power supply to avoid any electrical shock. As 

mercury is spreading at ground level, children and 

animals must leave the room immediatlely. Open 

the windows for ventilation and leave the room for 

approx. 15 minutes. It is also recommended to turn 

off  heating,  air  conditioning,  ventilators  or  wind 

machines. 

After ventilation you will have plenty of time to take 

care of a thorough cleaning. The remaining mercury 

will vaporize slowly under normal room temeprture. 

In case of a broken lamp the mercury can cling to 

fragments and vaporize in the room during the 

time. 

To prevent this take the following measures:

Put on disposable or household gloves.

Avoid violations due to glass fragments.

Sweep up all fragments with a cardboard, collect 

them in a container or  bag (e.g. preserving jar, 

plastic bag) and close it.

Use a moistened disposable household wipe or an 

adhesive tape to put up smaller parts. 

If you have used other utensils (e.g. a hand brush), 

wipe them with a moistened cleaning cloth after 

use. Put the utensils out to air.

Dispose cleaning cloth and cardboard in a dustbin. 

Please bring the container/bag with the glass 

fragments to your local collecting point for used 

lamps. In the meantime, store it outdoors if possible.

Use a vacuum cleaner if neccessary (e.g. on areas 

with carpets).

Air the room during the use of the vacuum cleaner 

and 15 minutes additionally after you have finished 

cleaning. 

Dispose the bags or the dirt of the vacuum cleaner 

in a dustbin.

Clean the container of your vacuum cleaner 

thoroughly. Wipe the floor nozzle  with a moistened 

cleaning cloth. To clean the vacuum cleaner, run it 

outdoors for approx. 15 minutes. 

DE

GB

FR

IT

ES

Gar

antie / W

arr

anty

Summary of Contents for BR-PH30













Reviews: