61
When clock reach the alarm time, alarm sound will start.
Where it can be stopped by following operation:
- Auto-stop after 2 minutes alarming if without any operation and the alarm will activate again in the next
day.
- By pressing
[ALARM / SNOOZE]
key to enter snooze that the alarm will sound again after 5 minutes.
- By pressing and hold
[ALARM / SNOOZE]
key for 2 seconds to stop the alarm and will activate again in
the next day
- By pressing
[ ALARM ]
key to stop the alarm and the alarm will activate again in the next day.
NOTE:
- The snooze could be used continuously in 24 hours.
- During the snooze, the alarm icon “
” will keep flashing.
4.4.3
UNIT SETTING
Use the
[ UNIT ]
key to change the unit of measure of the reading on the console display.
Below is the operation step:
- Press and hold
[ UNIT ]
key for 2 seconds to enter the unit setting mode.
- Short press
[ UNIT]
key to proceed to the next setting step.
- Press
[ / INDEX ]
or
[ / MODE ]
key to change the value. Press and hold the key for
quick-adjust.
- Press and hold
[ UNIT ]
key for 2 seconds to exit the unit setting mode at any time.
Setting items table:
Step
Mode
Setting procedure
1
Temperature unit
Press
[ / INDEX ]
or
[ / MODE ]
key to select °C or °F
2
Rain unit
Press
[ / INDEX ]
or
[ / MODE ]
key to select mm or in
3
Wind speed unit
Press
[ / INDEX ]
or
[ / MODE ]
key to select m/s, km/h, knots or mph
4
Baro pressure unit
Press
[ / INDEX ]
or
[ / MODE ]
key to select hPa, inHg or mmHg
5
Light intensity
Press
[ / INDEX ]
or
[ / MODE ]
key to select Klux, Kfc or W/m
2
4.4.4
BACK LIGHT
The main unit back light can be adjust, using the
[ HI / LO / AUTO ]
sliding switch to select the appropriate
brightness:
- Slide to the
[ HI ]
position for the brighter back light.
- Slide to the
[ LO ]
position for the dimmer back light.
- Slide to the
[ AUTO ]
position for the auto adjust back light that according to environment light level.
EN
