Insert the mounting plugs into the holes and
ensure the plug face is against the wall.
Insert the screws into the plug as shown. Only
use the screws provided.
Tighten the screws fully until the mounting plug
beds into the wall, then retract the screw so it
protrudes by 2.0mm.
Pull the wall control cable through the large hole,
remove the protective tape and plug the cable
into the wall control.
Feed the excess cable back into the hole and
slide the wall control over the protruding screw
heads. Pull the wall control down so the screw
heads engage with the slots on the back.
If the wall control rocks on the wall, remove it and
adjust the distance between the screw head and
the wall.
11