Brecknell LP250, User Manual

Page: 38 / 46

4.3.4 Set Black Mark Sensor as Media Sensor and Calibrate the Black Mark Sensor
Please follow the steps as below.
1. Turn off the power switch.
2. Hold on the button then turn on the power switch.
3. Release the button when LED turns
green/amber after 5 green blinks. (Any green/amber
will do during the 5 blinks).

The LED color will be changed as following:
Amber red (5
amber (5 blinks)
solid green
green (5 blinks) green/amber (5 blinks)
red/amber (5 blinks)
4.3.5 Set Gap Sensor as Media Sensor and Calibrate the Gap Sensor
Please follow the steps as below.
1. Turn off the power switch.
2. Hold on the button then turn on the power switch.
3. Release the button when LED turns
red/amber after 5 green/amber blinks. (Any red/amber
will do during the 5 blinks).

The LED color will be changed as following:
Amber
red (5 blinks)
amber (5 blinks)
solid green
green (5 blinks) green/amber (5 blinks)
red/amber (5 blinks)
4.3.6 Skip AUTO.BAS
TSPL2 programming language allows user to download an auto execution file to flash
memory. Printer will run the AUTO.BAS program immediately when turning on printer power.
32
Print Direction 0
Reference Point 0,0 (upper left corner)
Offset 0
Tear Mode On
Peel off Mode Off
Cutter Mode Off
Serial Port Settings 9600 bps, none parity, 8 data bits, 1 stop bit
Code Page 850
Country Code 001
Clear Flash Memory No
IP Address DHCP