8
EN
and the thermopot will be switched to the keep warm
mode, the keep warm indicator (19) «85» will light up.
The water temperature 85°С is set by default.
Notes:
the thermopot uses a long boiling technology
which significantly reduces the chlorine level in water.
• To avoid burns by hot steam, do not bend over the
steam release openings (7) in the thermopot lid (5).
Do not block the steam release openings (7) with any
objects.
•
Drain the water after the first boiling. Hot water
resulting from the first boiling is not recommended to
consume, you may use it for domestic needs.
ATTENTION!
Be careful when pouring out water to avoid burns
by hot water.
• Unlock the activation of the water pump by pressing
and holding the «Lock» button (18) within 5 seconds,
the indicator (17) will light up.
• To drain the water you can do the following:
First option:
place a suitable bowl, for instance, a cup
under the spout for pouring water (3) and press the
water (2) dispense button with a rim of the cup (pic. 3).
Second option:
place a suitable bowl under the spout
for pouring water (3) and press and hold the water
dispense button (16) «Water dispense», after the cup is
filled release the button (16).
Notes:
- the water is dispensed only when the indicator (17) is
switched on; if you pressed the button (18) «Lock» and
didn’t do anything, in this case the indicator (17) will go
out in 10 seconds;
- if you haven’t used the thermopot for a long time,
the water dispense may malfunction. In this case it
is recommended to open and close the lid (5) and to
switch the water dispense on again.
•
To switch the thermopot off disconnect the power
cord (22) plug from the mains socket.
• Open the thermopot lid (5) and wait until it cools
down completely.
• Always drain the remaining water from the thermopot
flask, to do this remove the lid (5).
• Before removing the lid (5) slightly open it at the
angle of approximately 45°, and pull the lid (5)
towards the control panel (4) (pic. 2).
• Carefully tilt the thermopot to drain the remaining
water (pic. 3).
• Install the lid (5) to its place; to do this, set the lid
(5) at the angle of approximately 45° and insert
the lid (5) to its installation place; before using the
thermopot make sure that the lid (5) is fixed properly.
Additional information
• The thermopot is equipped with rotating base (12).
You can turn the thermopot body (10) in the required
direction.
