- 3 -
Operation using mains power – 230v/50Hz.
Never use another source of energy at the same time (battery or gas). Ensure that the Gas hose and 12V DC
plug is not connected.
Check that the mains voltage corresponds to the operating voltage specified on the technical data label at the
back of the appliance.
If the electrical specifications are correct, plug the safety electrical connector into an earthed wall socket, which
is wired according to ruling regulations.
Turn the 230V thermostat knob (left) clockwise to MAX position.
After about one hour the effects of the cooling process will become visible: frost on the inside evaporator.
The thermostat enables the temperature of the fridge to be adjusted. After a cooling period of about 5 hours,
the thermostat can be set on a desired position; this position is influenced by the surrounding temperature and
the intensity of use. At the position min. the cooling process is stopped. The appliance is switched off by
removing the plug from the wall socket.
Operation using a battery (12 Volt DC).
Do not use another source of energy at the same time (mains or gas). Ensure that the Gas hose and 230V AC
plug is not connected.
A safety fuse must be installed in the power supply line between the battery and the fridge.
It is not necessary to check the polarity when starting up the appliance. Verify the voltage of the battery with
the voltage indicated on the technical data label at the back of the appliance.
When the appliance is powered by a motor vehicle battery, only switch the fridge on while the vehicle engine is
running.
When using a battery as a power source, there is no thermostatically controlled temperature regulation.
Pre-cool the fridge on the mains before starting a journey and try to put only pre-cooled or frozen products in
the fridge.
To start up the unit connect the supplied cable at the back in the 12v socket and put the corresponding side into
the cigar lighter socket of the vehicle. To disconnect, remove the connector from the cigar lighter socket.
IMPORTANT
:
If the appliance remains switched on when the vehicle is stopped, the battery will be
discharged and it may be impossible to restart the vehicles engine.
Operation using LP Bottle Gas.
Operation on gas is prohibited in closed areas, in vehicles and on boats. The appliance must be used in a well
ventilated area when operating on gas. This means that it can also be used under the canopy of a tent if
sufficiently ventilated. In all cases the location should be protected from rain and/or splashing.
Do not use another source of energy at the same time (12v or 230v). Ensure that the 12V DC plug and 230V
plug are not connected.
The gas cylinder must be stored in a cool, dry, ventilated area. Protect from sunlight and do not expose to
high temperatures.
