5
Uniko
Batteries:
This product requires 2 x 1.5 V alkaline batteries (LR03 AAA).
Please pay attention to the po/-.
ATTENTION: to keep the codes stored inside the memory do not press any
key during batteries replacement.
DIRECT CODE ENTRY
DTT or SAT
1) Turn on the decoder.
2) Look for the brand of your appliance in the code book (e.g. Digiquest- 0097)
3) Press and hold down OK+
keys of the Decoder (top left key) for
about 5 seconds until the LED lights up, then release the key.
4) Enter the code found in the booklet (e.g. 0097). If the code has been
entered correctly, the LED will go off.
If an invalid code has been entered, the LED will emit three short flashes.
Repeat the procedure from point 3.
5) Once the code has been entered, try to control the appliance.
If the code is not correct, repeat the procedure from point 2, inserting the
next code found on the booklet.
TV
1) Turn on the TV
2) Look for the brand of your device in the code book (eg Philips TV - 0024)
3) Press and hold the OK+
keys on the TV (bottom left key) for about
5 seconds until the LED lights up, then release the button.
4) Enter the code found in the booklet (e.g. 0024). If the code has been
entered correctly, the LED will go off.
If an invalid code has been entered, the LED will emit three short flashes.
Repeat the procedure from point 3.
5) Once the code has been entered, try to control the appliance.
If the code is not correct, repeat the procedure from point 2, inserting the
next code found on the booklet.
Note:
If no button is pressed, after 15 sec., remote control will exit the code
entry procedure and the LED will go off.
