2
Multi-Mixer Assembly & Use
Caution:
Ensure that the appliance is unplugged from the electrical
power source before changing attachments.
Mixer Gear Box (14)
• To attach the mixer gear box (14) to the Power Pack (1), line up arrows on the
Power Pack and Mixer Gear Box.
• Push Power Pack onto Mixer Gear Box until seated.
• Then while grasping Mixer Gear Box rotate it 90º clockwise until the arrow on
the Power Pack aligns with the “Square” on the Mixer Gear Box.
• To disassemble Mixer Gear Box and Power Pack rotate Mixer Gear Box 90º
counterclockwise.
Select the desired attachment, either the Dough Hooks (17) or Mixing Beaters
(16) and assemble to Mixer Gear Box (14) as noted below:
A)
Dough Hooks (17)
For use with light dough ONLY.
• Insert stem end of dough hooks (one at a time) into opening in base of
Mixer Gear Box (14). Insert the dough hook with the metal ring on the shaft
into the larger of the two holes in the mixer gear box. The metal ring must be
seated below the surface of the gear box.
• Rotate slightly while pressing gently until dough hook “Clicks” into place.
• Repeat for second dough hook.
• Ensure that dough hooks are well seated in Mixer Gear Box.
B)
Wire Whisk (15)
This attachment is used for beating air into mixtures such as egg whites, yolks
or creams..
• To install, place stem of Wire Whisk into either of the openings in the Mixer
Gear Box.
• Rotate Wire Whisk while pushing gently until Wire Whisk “Clicks” into place.
• Ensure that Wire Whisk is well seated in Mixer Gear Box.
C)
Wire Beaters (16)
Follow the same installation procedure for the Wire Beaters as detailed for the
Dough Hooks above.
9
Ice Crusher Attachment
Caution - Blades are sharp
.
Use extreme caution when handling the
blade, always hold it by the plastic hub.
Do not immerse Power Pack in
water or any other liquid.
Ensure that the gear box and blade assembly is well seated before turning
the unit on to chop ice.
Hold appliance with BOTH hands when chopping
ice
.
Ice Crusher Assembly and Use
Caution - Unplug appliance before changing accessories or cleaning.
• Place the blade support (7) into the tall ice crusher bowl (5). Then place the
Ice Crusher Blade (13) over the blade shaft.
• Assemble the Chopper Gear Box (8) as you would for the Chopping
Attachment. (See page 5.)
• Place ice cubes to be crushed into bowl.
Note:
Recommended size of ice cubes is 1 1/4” x 1” x 3/4”. Do not crush
more than 10 oz. of ice cubes at a time.
Warning:
This appliance is intended for intermittent use. When crushing
ice, use only bursts of 4 seconds each. Run time not to exceed
15 seconds before allowing unit to cool down.
Caution:
Hold both the bowl/gear box and power pack when chopping
ice.
Don’t
hold appliance by the power pack only.
Food Chopper Attachment
Caution - Blades are sharp
.
Use extreme caution when handling the
blade, always hold it by the plastic hub.
Do not immerse the cover and
gear box in water.
To store the unit, do not wrap cord around the power pack. Coil cord loosely
and use a twist tie to secure it in large loops.
To clean the power pack, processor cover/gear box, wipe off with a clean,
damp kitchen cloth. Towel dry.
