background image

ENGLISH     5

WARNINGS, CAUTION & LEGAL INFORMATION

To reduce the risk of fire or electric shock, 
do not expose the BRAVEN to rain or 
moisture while charging. The BRAVEN 
should not be exposed to dripping or 
splashing, and objects filled with liquids, 
such as vases, should not be placed on or 
near it while being charged or charging other 
devices. As with any electronic products, 
use care not to spill liquids into any part of 
the product. Liquids can cause a failure 
and/or a fire hazard. The power supply must 
be used indoors only. Make no modifications 
to the product or accessories. Unauthorized 
alterations may compromise safety,
regulatory compliance, and system 
performance, and will void the warranty. 
Do not place any flame sources, such as 
lighted candles, on or near the BRAVEN. The 
BRAVEN contains small parts that may be a 
choking hazard and is not suitable for chil-
dren under age 3. Do not continue charging 
the battery if it does not reach full charge 
within the specified charging time. Over-
charging may cause the battery to become 
hot, rupture, or ignite. If you see any heat 
deformation or leakage, properly dispose of 
the battery. Do not attempt to charge the 
battery in temperatures outside the range of 
32°-104°F (0°-40°C). If the battery begins 
to leak, do not allow the liquid to come in 
contact with your skin or eyes. If contact 
has been made, wash the affected area with 
plenty of water and seek medical attention 
immediately. Do not expose the product or 
battery to excessive heat, including direct 
sunlight or fire and storage or use inside cars 
in hot weather, where it can be exposed to 
temperatures in excess of 115°F (60°C). 
Doing so may cause the battery and power 
supply to generate heat, rupture, or ignite. 
Using the product in this manner also may 
result in a loss of performance and a 
shortened life expectancy. Extended 
exposure to direct sunlight may damage the 
external appearance and material qualities. 
Do not step on, throw, or drop batteries or 
the power supply or device, or expose them 
to a strong shock. Do not pierce, crush, 
dent, or deform the batteries or power 
supply in any way. If either becomes 
deformed, properly dispose of it. Do not 
short-circuit batteries. Do not attempt to 
service the BRAVEN yourself. Opening or 
removing covers may expose you to 
dangerous voltages or other hazards and will 
void the manufacturer’s warranty. To prevent 
risk of fire or electric shock, avoid 
overloading wall outlets, extension cords, or

integral convenience receptacles. Your
Bluetooth

®

 device (mobile phone, music 

player, tablet, laptop, etc.) must support the 
A2DP Bluetooth

®

 profile in order to work 

wirelessly with your new BRAVEN speaker. 
The A2DP profile is supported by most
recent mobile products with built-in
Bluetooth

®

 capability. Please refer to 

your device’s user manual for details and 
instruction regarding the Bluetooth

®

 profiles 

it supports. This device complies with part 
15 of the FCC Rules. Operation is subject to 
the following two conditions: (1) This device 
may not cause harmful interference, and (2) 
this device must accept any interference 
received,including interference that may 
cause undesired operation. NOTE: This 
equipment has been tested and found to 
comply with the limits for a Class B digital 
device, pursuant to part 15 of the FCC 
Rules. These limits are designed to provide 
reasonable protection against harmful 
interference in a residential installation. 
This equipment generates, uses and can 
radiate radio frequency energy and, if not 
installed and used in accordance with the 
instructions, may cause harmful interference 
to radio communications. However, there 
is no guarantee that interference will not 
occur in a particular installation. If this 
equipment does cause harmful interference 
to radio or television reception, which can 
be determined by turning the equipment 
off and on, the user is encouraged to try 
to  correct the interference by one or more 
of the following measures: — Reorient or 
relocate the receiving antenna. — Increase 
the separation between the equipment and 
receiver. — Connect the equipment into 
an outlet on a circuit different from that to 
which the receiver is connected. — Consult 
the dealer or an experienced radio/TV 
technician for help. CAUTION: Any changes 
or modifications not expressly approved by 
the party  responsible for compliance could 
void the user’s authority to operate the 
equipment. FCC RADIATION EXPOSURE 
STATEMENT: This device complies with FCC 
radiation exposure limits set forth for an 
uncontrolled environment. This device
complies with Industry Canada license-
exempt RSS standard(s). Operation is 
subject to the following two conditions: (1) 
this device may not cause interference, and 
(2) this device must accept any interference, 
including interference that may cause 
undesired operation of the device. 

Under Industry Canada regulations, this 
radio transmitter may only operate using an 
antenna of a type and maximum (or lesser) 
gain approved for the transmitter by Industry 
Canada. To reduce potential radio
interference to other users, the antenna 
type and its gain should be so chosen that 
the equivalent isotropically radiated power 
(e.i.r.p.) is not more than that necessary for 
successful communication. Lithium Battery 
installed is not intended to be replaced by 
the USER CAUTION: Danger of explosion if 
battery is incorrectly replaced. Replace only 
with the same or equivalent type. Where 
the MAINS plug is used as the disconnect 
device, the disconnect device shall remain 
readily operable. The device meets the 
exemption from the routine evaluation limits 
in section 2.5 of RSS 102 and compliance 
with RSS-102 RF exposure, users can obtain 
Canadian information on RF exposure and 
compliance. 

          
            Correct Disposal of this product. 
This marking indicates that this product 
should not be disposed with other household 
wastes throughout the EU. To prevent 
possible harm to the environment or human 
health from uncontrolled waste disposal, 
recycle it responsibly to promote the 
sustainable reuse of material resources. 
To return your used device, please use the 
return and collection systems or contact the 
retailer where the product was purchased. 

          
            This product complies with
California Energy Commission efficiency 
standards for consumer battery chargers.

Summary of Contents for BRV-360







Reviews: