Brave EZ Split, Owner/Operator And Safety Manual

Page: 20 / 72

Brave
18
800-350-8739
Operation
7 . DO NOT load another log or remove split
pieces until the pusher plate has
completely stopped and the control handle
automatically returns to the neutral
position.
Splitting Large Logs
When splitting a large log, or one in which the
wood is extremely tough or stringy (such as
elm), the first pass through the splitter may
not split the log into two sections. If this
happens, turn the log and split off small
sections. Repeat this process as necessary to
split the entire log.
General Maintenance Check (before operating)
The hydraulic system (hoses, cylinder, and pump) should be carefully inspected before
each use. Also, inspect the mechanical parts at the same time. Make sure all clamps,
nuts, bolts, fittings, etc. are properly installed and tightened.
Oil Level Check
NOTE: Place a clean container under oil level hole to catch any overflow of oil. Do not
allow excess oil to spill onto the ground.
It is critical that the proper hydraulic oil level is maintained. Oil level should be checked
periodically. Be sure the EZ Split is on a flat, level surface. Remove the screw from the
side of the oil tank. If oil does not run from the hole, oil level is low. Remove fill cap and
add oil SLOWLY until it runs from the oil level hole. Allow enough time for excess oil to
drain from the oil level hole. Re-insert the screw and tighten (do not over tighten)
making sure the O-ring is in place. Clean up any spilled oil and dispose of oil-soaked
rags properly.
WARNING
To prevent a fire hazard or possible explosion which could result in
serious injury, do not smoke or have open flames when checking the
oil. Do not spill oil. If oil should spill, quickly wipe up the spill and
allow the excess to evaporate before continuing. Make sure oil-soaked
rags are properly disposed of.