Brave EZ Split, Owner/Operator And Safety Manual

Page: 16 / 72

Brave
14
800-350-8739
Operation
WARNING
Do not attempt to operate the log splitter without fully understanding
all our instructions, safety precautions, and warnings. If any doubt or
question arises about the correct or safe method of performing
anything found in this or other
Brave’ manuals, contact your
Brave’ dealer or call the Sales and Service representatives at our main
headquarters. Proper care is your responsibility.
Before loading and operating the log splitter, put on
the proper protective gear, such as safety goggles,
face shield, hearing protection (ear muffs or ear
plugs), tight-fitting gloves (without drawstrings or
loose cuffs), and steel-toed shoes.
When operating the log splitter, make sure you are in the safe operating zone , as shown
in these pictures. You must stay in the safe operating zone at all times when the
pusher plate is in motion (whether extending or retracting). Never place any part of your
body into a position which would cause an unsafe operating condition.
1 . Set your log splitter on flat, dry ground.
Make sure you read all the
recommendations from the
“Safety”
section, before using the log splitter.
2 . Start the engine using the instructions from
the engine manual. If the log splitter has
not been running (cold engine), warm up
the engine and hydraulic system by
running the engine at half throttle for 3
to 4 minutes, then advance the engine
throttle control to maximum speed.
WARNING
Make sure you stay clear from the
engine
’s exhaust.
Hot exhaust is
intense and can cause serious injury.