11 Operating Instructions IQ-ONE / IQ-ONE+
Bräuniger GmbH
Vario Set-Mode
Press the Vario Key for three seconds to put the instrument
into Vario Set-Mode.
A-Int = Analogue Integrator
The basic damping of the Variometer is set here.
Four levels are displayed. The damping corresponds with the
following times.
Level
1
2
3
4
Damping about 0.5s
1s
2s
3s
This setting influences all further filters.
It can also be used as a turbulence filter.
Still air
= 1
Turbulent air
= 3 to 4
Vario Option-Mode
Further long pressure on this key in the Set-Mode brings the
instrument into Option-Mode.
Option 1 Unit
Set units
Set the required unit for the Vario display here. The options
are m/s or ft/minx100.
Option 2 d-Int
Digital Integrator
The digital integrator can be set from 1s to 30s.
Option 3 Audio
Audio threshold (dead band)
Use the Arrow Keys to set the threshold for the climb tone.
The level can be set from 4 to 100 ft/min, and is displayed on
the analogue vario scale (each segment on the scale equals 4
ft/min). The example on the left shows a setting of 12 ft/min.
This means the vario will start beeping when your climb rate
reaches 12 ft/min.
.
3s
[short-press Vario Key]
