Page 0
Inner roll stop
Linkage Rod
H
1. Position the lift platform below stow
level.
2. Loosen the jam nuts at each end of
the linkage rod. Adjust rod length as
needed. Minimize adjustment.
3. Carefully check the inner roll stop angle
and operation using the
hand pump.
Ensure the linkage rod has not been
over adjusted resulting in pressure on
components (damage will result).
4. Tighten the linkage rod jam nuts.
Do not adjust
the
inner roll
stop
linkage
rod unless
extra usable
platform length
is needed.
See Photo G.
CAUTION
CAUTION
CAUTION
CAUTION
Improper inner roll
stop linkage rod
adjustment may
result in lift damage.
If the angle of the inner roll stop (when in the
vertical position) restricts the usable platform
length for the wheelchair passenger, adjust
-
ment of the linkage rod will change the angle.
Adjust the inner roll stop as detailed in the pre
-
vious procedures. Then, adjust the linkage rod
as detailed (only if necessary). If the linkage
rod is over adjusted (too long or too short), it
will exceed the travel of the slider block result
-
ing in damage to the cam follower bearing, the
cam and/or other components.
Linkage rod adjustment affects angle
of inner roll stop (vertical position).
31756-001.ai
G
Floor Level and Inner Roll Stop Adjustments
Usable Platform Length
Linkage Rod Adjustment
