10
Manual C118 EN Rev04
04.2017
10
Power Supply
Mostly used, for best flexibility, are batteries (MN1500x4)
or re-chargeable cells (IECR6). They are inserted into the
battery case underneath.
Further, the supply unit U1H008 may be used. Its output
cable will be plugged into the front side metallic jack.
Note:
The supply unit cannot re-charge the cells. To re-charge
those, they must be inserted into the charger unit U1H009.
To remove the battery case cover, pull it to the rear, as
indicated by OPEN. If necessary, use a knife blade.
When inserting the batteries or cells, watch for their correct
polarity, as indicated by symbols at the bottom of the case,
opposite to each other. Then re-insert and close the case
cover.
Part No. of the case cover: BOS800-802-B.
Powered by
batteries, cells,
or from mains by
supply unit
Battery
replacement
Power ON/OFF
The ON/OFF key switches power to the instrument. Further
it may be programmed to automatically switch off by itself,
when idling for approximately 10 min. Saves the batteries,
if unit inadvertently left on.
Function and characteristics used prior to shut-off are
memorized. Thus, the instrument returns to continue the
last job.
Measurements and memorized MAX/MIN/AVG values
however are cancelled.
The instrument automatically checks for adequate supply
voltage. In the critical phase, readings periodically alternate
between measurements and LP (low power), still being val-
id. It is time, however, to replace the batteries.
When the supply voltage drops to an inadequate level, the
display locks, reading the last measurement, or LP. If the
instrument is switched on under not adequate power, the
display remains blank or may show illegible signs.
ON/OFF
Supply voltage
monitor
Summary of Contents for MOVIPORT C118 Series
Page 2: ......
