9
For best results:
Always shave before washing your face.
At all times, hold the shaver at right angles (90°) to the
skin (b).
Stretch the skin and shave against the direction of hair
growth.
For pre-shaving after a few days of not having shaved, use
the wide shaper (4a) to pre-cut long hairs. For a close,
smooth shave, finish with the foil.
To maintain 100% shaving performance, replace your foil
and cutter block at least every 18 months or when worn.
Using the rotating styler
(4)
The wide shaper (4a) evenly cuts and trims large areas (c).
It is ideal for shaping sideburns, moustaches and partial
short beards. The wide shaper is provided with safety rips
and a gliding strip for less irritation and easy gliding. Press
the blue stripes to push up the rotating styler (4).
While stretching the skin, guide the wide shaper against the
direction of hair growth.
The narrow shaper (4b) precisely defines lines and edges (d),
being ideal for precise contouring.
To use the narrow shaper, push up the styler and turn it 180°.
Frequent use of the styler (4) will reduce the battery capacity.
Using the trimming attachments
(7)
and
(10)
The trimming attachment (7) is ideal for beard trimming
and keeping it at a constant length.
Place the trimming attachment onto the shaver foil (2) and
press it against the shaver housing until it snaps into place
with a click.
Press the beard length selector (8) (e) and slide it up in
order to set the desired beard length (length settings from
top to bottom):
0.04 in / 1.2 mm
0.11 in / 2.8 mm
0.17 in / 4.4 mm
0.23 in / 6 mm.
Push up the styler (4).
Activate the on/off switch and trim against hair growth by
guiding the transparent comb part over the skin.
The short beard attachment (10) is perfectly suited for
creating a stubble look and maintaining it. Attach the
short beard attachment the same way as the trimming
attachment (7). Push up the styler and use the appliance
as shown (f). The short beard attachment ensures an
optimum usage angle.
•
•
•
•
•
•
•
•
•
•
99321066_Cruzer_Z50_NA.indd 9
99321066_Cruzer_Z50_NA.indd 9
15.07.2009 12:08:24 Uhr
15.07.2009 12:08:24 Uhr