Page 3
For technical questions, please call 1-888-866-5797.
Item 56163
Operation Instructions
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this document
including all text under subheadings therein before set up or use of this product.
NOTE:
Before using Work Light / Battery Bank
for the first time, fully charge the Battery.
1. To adjust angle of Work Light, pull on the
Handle and set to one of five detent positions.
2. Press Power Button on back to select
from five operating modes: High, Low,
SOS signal, Flashing, and OFF.
3. When finished using the Work Light,
store indoors away from children.
Charging USB Devices
1. Verify Work Light
/ Battery Bank
is fully
charged and recharge as needed. Refer
to
Charging Instructions
on page 2.
2. Open the Charging Port Cover and plug the USB
cable from the device to be charged into the USB
Output Port. Refer to Figure A.
3. Plug the other end of the USB Cable into the
device to begin charging. Refer to Figure B.
Note:
During device charging the battery
indicator lights will display the remaining power
level in the Work Light / Battery Bank.
4.
When charging is complete, disconnect the USB
Cable from the device and the Work Light.
5. Recharge the Work Light
/ Battery Bank.
Figure B:
Charging Mobile Device (not
included) with Work Light
/ Battery Bank
Battery Removal
NOTE:
Contains Li-Ion battery. Battery must
be recycled or disposed of properly. Do not
open, crush, heat above 140° F or incinerate.
1. Unplug USB Cable from Work
Light (if connected).
2. Remove four screws from back of
Work Light, then remove cover.
3. Disconnect Battery wires from circuit board.
4.
Remove Battery.
Screws
Battery
Cover
Battery
Wires
Figure C:
Work Light open for Battery removal