Quoizel, Inc.
6 Corporate Parkway
Goose Creek, SC 29445
Customer Service
Phone 631.273.2700
Fax
631.231.7102
www.quoizel.com
Tools Required:
Flathead screwdriver, Phillips screwdriver, pliers, wire cutters, wire strippers, electrical tape,
safety glasses.
Estimated Assembly Time:
30-45 minutes
Preparation:
Identify and inspect all parts before beginning installation. Check package content list and diagrams
below to be sure all parts are present. If any parts are missing or damaged, do not attempt to assemble, install, or
operate the fixture. Contact customer service for replacement parts.
Warnings and Cautions
1of2
Assembly Instruction Sheet #IS-TML9008K
For Style TML9008K
Bulb Recommended:
(3) Candelabra Base 60W Maximum, Alternate bulb (3) 13W CFL
6 CORPORATE PARKWAY
GOOSE CREEK SC 29445
www quoizel com
,
.
.
.
Thank you for purchasing a Quoizel product.
Need assistance with parts or assembly? Call Quoizel customer service at 1-631-273-2700
or visit us on-line at www.quoizel.com
2014 QuoizelInc.
February2014
Turn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if in doubt.
These instructions are provided for your safety. It is very important you read them completely before installing the fixture. We strongly
recommend that a licensed, professional electrician perform the installation.
Disconnect fixture from power source before replacing bulbs. Make sure bulbs are given sufficient time to cool before removal. Do not subject
glass parts to any shock while in operation or shattering may result.
Package Contents
C
Fixture
Body
x 1
A
Mounting
Screw
x 3
B
Glass Panel
x 4
STEP 2
-
Attach Glass to Fixture
Body
A. Attach Glass Panels (B) on the
Fixture Body (C).
Figure 2
C
B
STEP 4
-
Attach Fixture Hood
A. Thread the Stem onto the
Coupling inside of Fixture Body
(C), hand tighten until sung.
B. Place the Fixture Hood and the
Waterproof Washer over the
Stem. Secure by threading the
Finial onto the Stem. Hand
tighten until snug.
Figure 4
G
Coupling
STEP 5
Drill Pilot Holes on
Post
-
A. Carefully fit the Post Fitter over
the end of the Post (not
supplied), making sure the
Post Fitter is fully seated.
B. Mark the drill point for the (3)
Mounting Screws, using (3)
Mounting Holes as reference.
After marking hole locations,
remove fixture from post and
drill 1/16” pilot holes for
screws.
Post
Post Fitter
Figure 5
STEP 3
Install Bulb
-
A. This fixture uses candelabra bulb
with a candelabra screw base.
Maximum 60 watts.
B. Insert bulb and screw snugly into
place.
Figure 3
Bulb
Socket
STEP 1
Seperate the parts from
the fixture
-
A. Unscrew the Finial, remove the
Waterproof Washer, the Cap
and the Stem from the fixture
(C).
Figure 1
C
Finial
Cap
Waterproof
Washer
Stem
Finial
Cap
Waterproof
Washer
Stem
