8
Figure 4
ELECTRICAL INSTALLATION
This product must be wired in adherence with the SAE J1939/11 specification. Failure to do so may result in
sporadic operation or non-operation.
While this device is designed to reside on a standard J1939 CAN network, it is recommended that Akron Brass
CAN products operate on their own CAN network isolated from the other CAN networks on the vehicle.
The following is intended to provide the basic instructions for installation and operation of the 6035 CAN Joystick. Refer to Figure 4,
Figure 5, and Figure 6 for additional information. Wiring must be in compliance with SAE J1939 for proper operation.
Step 1
Connect Battery Positive to Pin #1 (use of Akron Brass Harness stub part number 721579 is recommended)
Step 2
Connect Battery Negative to Pin #2
Step 3
Connect CAN HI to Pin #3 (Akron Brass Harness stub part number 721579 already has this pin properly connected to a J1939
CAN network stub connector)
Step 4
Connect CAN LO to Pin #4 (Akron Brass Harness stub part number 721579 already has this pin properly connected to a J1939
CAN network stub connector)
Step 5
Add a terminating resistor if this device is at the end of the network.
Switch 1
Switch 2
Switch 3
Connector Laber
