Brandt WBF1114U, Instructions And Maintenance Booklet

Page: 5 / 16

5
ENGLISH
Stop/start button
Once you have selected the programme
you require, press this button to start your
washing machine (the button sticks out
from the control panel). The “ON” light will
come on after a few seconds, during which
time the Door Safety device is activated.
If the programme is completed without
interruptions, you can open the loading
door once the programme is over and yo
have waited for the Door Locking Safety
device to the deactivated (about 2
minutes). The “ON” light will go off to
indicate this.
When your washing machine is in
operation,
the wash cycle can be
interrupted by pressing the Stop/Start
button. The “ON” light will go off. Press the
Stop/Start button again, to start your
washing machine from the phase of the
cycle where it left off. If you stop your
machine from the phase of the cycle where
it left off. If you stop your machine to add or
remove garments, make sure that the water
level not so high the it could overflow when
the door is opened. Also make sure that the
temperature inside the drum is not too
high. Remember that even though the
“ON” light goes off, you have to wait about
two minutes until the door safety device is
deactivated before you can open the door.
Additional functions buttons
By pressing these buttons, you can include a
series of additional functions and features in
the wash programme you have selected.
These functions and features will enable you
to adjust the wash to your particular needs
and requirements.
These functions are activated when the
button sticks our form the control panel,
enabling you to see the symbol printed on it.
Depending on the model, your washing
machine will have some of the following
functions.
No Sping button
Press this button to eliminate the Spin
phase from any programme selected. This
will help to avoid creasing when washing
special fabrics.
Sping selector button
Press this button to reduce the spin speed.
This function is specially recommended for
washing clothes which are very worn or
have a special finish.
Creaseguard button
Press this button to interrupt the last rinse
and hold the clothes immersed in water
inside the drum to avoid creasin. Press the
button again to complete the programme.
Or select the drain-only programme to
avoid the spin cycle.
Extra Rinse Button
Press this button to increase the final rince.
This increases water consumption.
Cold Wash Button
Press this button to select a vold wash pro-
gramme.
Load Button
In the models which do not have the
Automatic Variable Capacity feature, press
this button to save water by reducing con-
sumption when washing small loads.
Loading the machine
Opening the door
In order to open the door, pull outwards on
the handle (Figure 1-3).
Loading the drum
When loading clothes into the drum, you
should bear the following points in mind:
- Make sure all the pockets are empty.
- Stretch out and unfold each item.
- Put the items into the drum one by one,
so that they do not get tangled up toget-
her.
1/2
000 000 000 000
900
500 1300
800