Connect the cold water supply hose to a threaded 3/4 (inch) connector and make sure
that it is fastened tightly in place.
If the water pipes are new or have not been used for an extended period of time , let the
water run to make sure that the water is clear. This precaution is needed to avoid the
risk of the water in let to be blocked and damage the a ppliance.
please close the hydrant after using.
23
The following things should be checked before starting the dishwasher.
The content of this manual is very helpful to the users.
After installation, please make sure to keep this manual.
1
The dishwasher is level and fixed properly
2
The inlet valve is open
3
There is a leakage at the connections of the conducts
4
The wires are tightly connected
5
The power is switched on
6
The inlet and drain hoses are knotted
7
All packing materials and printings should be taken out from the dishwasher
Syphon Connection
Extension Hose
If you need a drain hose extension, make sure to use a similar drain hose.
It must be no longer than 4 metres; otherwise the cleaning effect of the dishwasher could be reduced .
Water Outlet
Connect the water drain hose. The drain hose mu st be correctly fitted to avoid water lea ks.
Ensure that the water dra in hose is no t kin ked or squashed.
Positioning the Appliance
If th e sink is 1000mm higher from the floor, the excess water in hoses cannot be dra ined directly
into the sink. It will be necessary to drain excess w ater from hoses into a bo wl o r suitable
containe r that is held outside and lower th an the sink.
Position the applianc e in the desired location. The back should rest against the wall behind it, and the sides,
along the adj acent cabinets o r wa lls. T he dishwasher is equippe d with water supply and drain hoses th at can
be positioned either to the righ t or the left s ides to facilitate proper instal lation.
How to Drain Excess Water From Hoses
The waste conne ction must be at a he ight of between 40 cm (minim um) and 100 cm (ma ximum)
from the bottom of the dish. T he water drain ho se should b e fixed by a hose clip. The free end of
the hose must no t be immersed in wat er.
