Installing your dishwasher
33
EN
Tap: with threaded end, 20/27mm
dia. (3/4” BSP)
Flow: 10l/min. minimum
Pressure: 1 bar to 10 bars
(0.1 - 1 MPa)
In the event of high pressure, it is
advisable to fit a pressure regulator.
Your Water Company will give you
the necessary information.
Length of the water supply pipe
(standard unit): 1.50m
Connecting the hot water:
Check that your original hose is
designed for connection to the hot
water supply (red marking on the
hose).
If necessary, you can alter the
hose’s direction. To do this, loosen
the connection at the bottom left
on the rear of the machine and
swivel it as necessary. Fully tighten
the connection again and check
that there are no leaks.
For dishwashers fitted
with safety hoses:
You must remove the
protective cover (see
the drawing opposite)
to alter the hose’s
direction. To do this,
loosen the two
screws (end fitting
T20), remove the
protective cover,
position the
connection in the
direction you wish and then
replace the protective cover.
If you use a self-
piercing tap, check that
there is sufficient water flow.
When the tap is on the left-
hand side of the machine, use the
“anti-kinking” hook supplied with the
machine to avoid any risk of the
supply hose* kinking while you are
fitting your dishwasher.
(* For large diameter safety hoses-
depending on the model)
Check that the
seal is fitted
and that the
connection is
tight.
When you are making a
new installation, you must
use a new hose to connect the
machine to the water supply: you
must not re-use the old hose.
Water connections
“Hazardous Voltage” symbol
(depending on the model)
the hose is fitted with an electrical
device
Important :
check the water’s
hardness: all the
information you
require is provided in
the Chapter
“Adjusting the water
softener” in your
operating instructions
manual.
0,1 - 1 MPa
