36
For your own safety, you must comply with the instructions given below.
The electrical installation must comply
with Standard NF C *15-100, in particu-
lar concerning the Earth.
Three-core flex 3x2.5 mm², 230V single-phase
connected to:
•
A 20A single-phase 230V-50Hz supply
•
An ELCB and an individual fuse (10 or
16A depending on the model)
We cannot be held responsible for any
incident caused by faulty electrical ins-
tallation.
Recommendations for the electri-
cal installation of your appliance :
•
Do not use extension leads, adap-
tors, or socket strips.
•
Always make sure your circuit is
earthed.
•
The socket must always remain ac-
cessible, yet be out of the reach of
children.
If you have any doubts, contact
your installer.
If the appliance has been delivered to your home in a horizontal position, stand it
upright and then wait 2 hours before plugging it in. A small amount of oil may have
flowed into the refrigeration circuit, and you must allow time for this to flow back
towards the motor before connecting the appliance. Failure to do so may damage
the appliance.
Carry out an initial cleaning operation (see the section on "Installing your applian-
ce") before connecting your appliance to the electrical supply. Disconnect your ap-
pliance prior to performing any maintenance operation. Grasp the plug directly,
instead of pulling on the power cable.
Electrical connection
EN
Your appliance is compliant with Eu-
ropean Directives CEE/73/23 (low
voltage directive), CEE/89/336
(electromagnetic compatibility) and
CEE/96/57 (energy efficiency) as
well as their modifications.
Summary of Contents for CE3020
Page 26: ...26 Notes FR...
