Brandt BHC6601B, Manual

Page: 21 / 52

Cupboard mounting installation:
1.
Drill a 130mm diameter and four 3.5mm
diameter hole as below picture.

ATTENTION : If your cooker hood works
at circulating-air mode, it is not necessary
to drill 130mm diameter hole.
2.
Use the 4 screws to fi x the cooker hood
to a kitchen cupboard .Check that your
fi xings are correctly located, by temporarily
fi tting the cooker hood. If correct, fi t the
unit into position. Tighten the screws if
necessary.
Wall mounting installation:
1.
To mount on the wall, drill two 10mm diameter
holes 538/696mm with the vent hole on the top
of the cooker hood in the middle as below picture.
Make sure the hood is aligned directly over the hob.
2.
Insert two plastics wall plugs
(supplied) into the holes.
3.
Insert two screws into the upper two plastic wall
plugs and tighten them leaving 3mm protruding
from the wall.
4.
Mount the cooker hood onto the two screws and mark
the bottom two screw positions.
5.
Remove the hood and drill the bottom two screw
holes and Insert the plastic wall plugs.
6.
Mount the hood on the top screws, Insert the bottom
screws and fully tighten all the screws.
Information
The air must not be discharged into a fl ue that is used for exhausting fumes
from appliances burning gas or other fuels.
130
480/696
70
100
180
538/696
21