Brandt BFL484YNW, Instructions For Use Manual, Page: 28 / 40

Special flange
self-tapping screws
Earth wire
①
②
③ Upper hinge part
Note: Please hold the door by hand
during step 4 to prevent door dropping.
5. Remove the door and place it on a
smooth surface with its panel upwards.
Lever
part
①
and part
④
,then loose
screws
②
, as shown in the picture.
Change handle
③
to the right side, then
install screws
②
, part
①
and part
④
in
turn. Loose screws
⑦
, detach part
⑥
and part
⑤
, turn part
⑥
over and then
install part
⑤
and part
⑥
to the left side
with screws
⑦.
②
Special self-tapping screws
③
Handle
①
Handle covers
④
Screw hole covers
⑤
Door holder
⑥
Stop block
⑦
Self-tapping screws
1
2 3 4
Note 2
:
Install the handle cover as
the follow figure shows :button the
buckle firstly , and then close the
cover from the inside until you hear
the sound of "popping" .
Note 1: Remove the handle cover as
the follow figure shows :bend the
upper wing and take the upper
buckle apart from the handle , and so
as the other side , after that take
down the handle cover .
6. Place refrigerator flatwise, remove
part
③
and then loose screws
④ .
Remove part
②
and part
①.
Note: washer may
stick to door.
washer
②
Front foot fixed board
④
Self
-
tapping screws
③
Adjustable bottom feet part
①
Lower hinge part （ right ）
7. Screw out lower hinge, change it to
the near hole site, and then screw up
and mount washer.
8.Just remount to the step 6,change
part
①
to left and part
②
to right and then
fix them with screws
④ .
Finally install
part
③.
Lower hinge part (left)
XXXXXXXXXXXXXXXXXXXXXXXXX
25
vvv
ccc
ccc
ccc