18
19
EN
3. INSTALLATION
Position the appliance and allow it to stand
for two to three hours before it is turned on
for the first time to allow the system to settle.
Do not position next to any heat source e.g.
cooker, boiler or in direct sunlight etc.
Allow at least 10 cm of space at the top
and 10 cm of space on both sides of the
appliance and between the back of the
appliance and the wall for adequate air
circulation. The appliance is not designed for
recessed installation (“building in”).
Install on a good firm level surface, and any
unevenness of the floor should be corrected
prior to installation, slight unevenness can be
overcome by adjusting the front feet.
NOTE:
if the appliance is positioned
on a carpet, soft floor covering you should
readjust the front feet once the appliance has
had time to settle.
Additional spacers for better
performance
There are 2 additional spacers supplied. It is
recommended to install these 2 spacers to
your fridge-freezer as per the diagram below.
NOTE:
The fitting of these spaces is
not essential but will ensure that there is
sufficient space for air circulation and better
cooling performance.
