Brandt BDB424DX, Instruction Manual

Page: 29 / 74

Error Codes Error Codes
Overflow.
When some malfunctions come on, the appliance will display error codes to warn you:
Codes
Meanings
Possible Causes
Longer inlet time.
Faucet is not opened, or water intake is
restricted,or water pressure is too low.
Some element of dishwasher leaks .
E1
E3
Problem Possible Causes What To Do
The dishes were not
loaded correctly. See notes in " Loading the Dishwasher Baskets ".
The dishes
are not clean
Cloudiness
on glassware
Black or gray
marks on dishes
Detergent left in
dispenser cups
The dishes
are not drying
Select a more intensive programme.
See" Wash Cycle Table ".
Use more detergent, or change your detergent.
Rearrange the items so that the spray can rotate freely.
Clean and/or fit the filter combination correctly.
Clean the spray arm jets. See "Cleaning the Spray
Arms".
Use less detergent if you have soft water and select
a
cycle to wash the glassware and to get
them clean.
shorter
Use a mild abrasive cleaner to eliminate those marks.
Re-loading the dishes properly.
Load the dishwasher as suggested in the directions.
Increase the amount of rinse-aid/refill the rinse-aid
dispenser.
Do not empty your dishwasher immediately after
washing. Open the door slightly so that the steam can
escape. Begin unloading the dishwasher only once t
he dishes are barely warm to the touch.
Empty the l
ower basket first to prevent any water from dripping
into the lower basket.
With a short program, the washing temperature
is lower, decreasing cleaning performance.
Choose a program with a long washing time.
Water drainage is more difficult with these items.
Cutlery or dishes of this type are not suitable for
washing in the dishwasher.
The programme was
not powerful enough.
Not enough detergent
was dispensed.
Items are blocking
the path of spray arms.
The filter combination
in the base of wash
cabinet is not clean or
is not correctly fitted.
This may cause
the spray arm jets
to get blocked.
Combination of soft
water and too much
detergent.
Aluminum utensils
have rubbed against
dishes.
Dishes block
detergent cups.
Improper loading
Too little rinse-aid
Dishes are removed
too soon
Wrong program
has been selected
Use of cutlery with
a low-quality coating
Unsatis
-factory
washing
result
Unsatis
-factory
drying
result
Ed
WARNING! WARNING!
If overflow occurs, turn off the main water supply before calling a service.
If the base pan overflows:
- Turn off the main water supply before calling for service
- Remove the excess water before restarting the dishwasher.
26
E4
Not reaching required temperature. Malfunction of heating element.
Open circuit or break wiring for
the communication.
Failure of communication between main PCB
with display pcb.