Brandt AD9905B, User Manual

Page: 6 / 12

16
LED LIGHT REPLACEMENT
CHARCOAL FILTER REPLACEMENT
Remove the charcoal filter from the blower as shown.
Fit in the new charcoal fiter.
Before attempting to replace the light bulb, make sure that the light switch is
turned off. Remove the grease filter to access the lamp area. Remove the
damaged LED light and replace with a LED light maximum 5 W.
16



Vent System
3
The length of the ductwork and the number of elbows should be kept to a
minimum to optimise performance. The size of the ductwork should be
uni- form. Do not install two elbows together. Ensure all joints in the
ductwork system are sealed well. Use caulking to seal exterior wall
or floor opening around the cap.
(e.g. charcoal filters) before use.
This product is intended for domestic use and the household environment
only. The product is not intended for an outside use or in a commercial setting.
Do not leave the product unattended during operation. Brandt Asie Pte
is not liable for damage caused by improper use or incorrect operation.
Determine which venting method is best for your application. Vented
(non- recirculating) system terminates on the outside. Ductwork may
be extended either through the wall or the roof. Do not terminate the
vent system in an attic or other enclosed area.
Cleaning & Maintenance
SURFACES : Wash with warm soapy water and a soft sponge. Never
use harsh or abrasive cleaning agents,cleaning agents with high alcohol
content, hard scouring pads or cleaning sponges or high-pressure
cleaners or steam cleaners on any part of this appliance as this will
cause irreparable damage.