INSTALLATION INSTRUCTIONS
7631 Instructions 5-30-14.doc
Page 3 of 4
IMPORTANT:
If the Gray 22-pin connector is
present in the vehicle and Pins 15 and/or 16 are
already populated, remove the terminal(s) using
Delphi Terminal Removal Tool #12094429 or a
Small Flat Watch Repair Screwdriver and isolate
with Electrical Tape.
Step 10:
Locate pin position 15 on the Gray
22-pin radio connector (Figure 1) and insert
Red terminal of Display Harness until it clicks
securely.
Step 11:
Insert Black terminal of Display
Harness into pin position 16 on the Gray 22-
pin radio connector (Figure 1) until it clicks
securely.
Step 12: Connect Gray 22-pin Connector to
radio along with all remaining radio
connectors before reinstalling radio head
unit and all trim removed.
Step 13: Route supplied Chassis Harness
under carpet to the center console area.
CAUTION:
Keep harness away from accelerator,
brake pedal, and parking brake assembly.
Step 14: Connect Power Harness male RCA
connector to Display Harness female RCA
connector.
Step 15:
Using a vehicle specific service
guide/wiring diagram and a multi-meter
verify 12v Ignition power source.
Red wire
of power harness connects to 12v+ Ignition
power and Black wire of power harness to
Black chassis ground nut or wire.
RECOMMENDED
:
Solder wires and cover with Heat
Shrink Tubing or use T-taps as an optional
connection method.
Step 16: Connect Chassis Harness to supplied
Power Harness RCA and power plugs.
Step 17: Use Wire Ties or Electrical Tape to
secure Chassis Harness and Jumper Harness
RCA and power connections
.
Step 18
:
Coil any excess
Chassis Harness and
secure it and the Jumper Harness to existing
vehicle wiring with Wire Ties or Electrical
Tape.
Step 19: Dealer Programming Instructions
PARK VIEW REAR BACK-UP CAMERA
VEHICLE CONFIGURATION
Vehicle VIN must be updated with the sales code of the
added accessory in order to enable system functionality.
Using the DealerCONNECT website and the scan tool,
complete the procedure below:
A.
Log on to https://dealerconnect.chrysler.com
B.
In the “Vehicle Option” screen under “Global Claims
System” category in the “Service” tab, enter the
VIN and add the following sales code: XAC (PARK
VIEW REAR BACK-UP CAMERA) as a “Dealer
Installed Option.”
C.
Confirm that the new sales code has been
successfully added to the VIN. With the scan tool
connected to both the internet (via Ethernet port or
wireless connection) and the vehicle, perform the
following steps:
